Replacement Upvc Window Handles
The majority of replacement windows handles made of upvc include everything you need. However the handle you had previously was secured by pins or screws, they’ll need to be removed. Remove the’snap-in’ covers at the base of your handle.
Next you will need to identify the type of window and lock that your new handle It is essential!
Espag
Espag handles are a multipoint lock system that is fitted to casement windows such as uPVC and wooden double glazing. The handle is fitted with a 7mm square shaft that fits into an internal gearbox that is mounted on the uPVC window. When the handle is turned, it triggers a series of locks around the perimeter of the window. Espag handles are also referred to as shootbolt handles and offer additional security when compared to the conventional single point lock that is found on older frames.
They are available in a range of different designs, domestic including inline and cranked handles that can be used either left or right hand operation. There are also ergonomic handles that enhance the appearance and feel of your window as well as the handle.
You’ll need to measure the size of the spindle from the base of your uPVC handle if you wish to purchase the correct replacement. This measurement, referred to as the step height, will help you select the best uPVC window handle for your home.
If you require to remove any screws that are holding the handle, use a screwdriver or pliers. Once you have done this then you need to take the handle apart by removing the screw or pins that hold the spindle before pulling it away from the window.
After you have removed the handle, you can open the locking mechanism inside the frame of the windows and take out the cockspur block that is attached adjacent to the handle. This will allow the window to be opened. The new uPVC handles you have ordered should be able slide onto the cockspur block and then into the handle spindle, allowing the window to open again. If you’d like to make sure that your uPVC handles are securely secured and secure, you should replace the cockspur block a brand new one.
Cockspur
Cockspur handles can be found on older uPVC or aluminium windows. The handle closes and turns into a wedge-shaped receiver catch. (Not to be confused with timber latches, which are also covered in this section.) These handles are available in lockable and nonlockable versions. They are available in a variety of different nose heights to fit the frame.
The handle locks with the slender spur (little triangle bit) pulling against a wedge of plastic that is fixed to the frame. These are generally one way handles, however a locking deadlock cylinder can be added for extra security.
Like the Espag handles cockspur handle replacements are simple to install, all you need is new screws (supplied) and the correct backset. The backset is measured from the baseplate to the underside of the nose of the handle. Aluminium window frames are usually 9mm wide, while UPVC is 21mm wide. There are a myriad of variations though so it is important to measure before buying the handle (see video below for how).
This type of window handle can be substituted by simply removing the existing handle and then removing the spindle, or in certain instances, the entire handle assembly. The new handle can be secured with two pozidriv screws. The pozidriv screw comes in a brass or a zinc finish to match the existing hardware. There is also an option of a self-locking pozidriv screw.
This cockspur handle is simple to install and is ideal to repair or replace old uPVC Windows. They are a universal design that makes them suitable for all backsets and profiles. Each handle comes with three packers, each with different thicknesses. They are slid on the underside of the handle noses and can be used together to achieve backsets as small as 9, 13mm, or as high as 21mm. They are available in left and right handed versions and come in either lockable or nonlockable models with a variety of nose heights.
Tilt and turn
Tilt and turn windows are a coveted European window design that has been around for Double glazed windows replacement (samkwang.eowork.co.kr) a long time in Europe however, it is only just starting to catch on stateside. The windows are a combination of 3 window styles — tilt, in-swing and pivot. This makes them perfect for older homes as they are able to provide more ventilation than traditional window types.
When tilt and turn windows are closed, they are locked like any other fixed window. But, by turning the handle 90° or 180@ (depending on the kind of tilt and turn window) the window sash will open inwards and the window will tilt in order to allow air circulation through the gap at the top of the frame. This is a great solution to allow ventilation without having to open a large windows, which could pose a safety danger if not properly secured when opening.
If the handle is turned another 90or 180 degrees the sash will be fully opened like the door. This allows for full air exchange, which is particularly beneficial in rooms with a lot of draft or houses where odors from smoke or other sources are likely to accumulate. This allows you to easily clean the outside of the glass since you can do it from inside your home. This is a task which often requires precarious steps.
Tilt-and turn windows are also safe. When locked in a closed position, they are difficult to open from the outside, and they have double seals that prevent rainwater from entering the home when in the tilted or in-swing position. This feature is particularly beneficial for older homes where intruders tend to target traditional windows which can be opened using side hinges.
Spade
There are several different types of handles that can be installed on upvc double-glazed windows. The two main types are Espag handles and Cockspur handles. There are also tilt and turn handles blade or spade handles and monkey tail handles. The type of handle you pick will be based on your preferences and the kind of windows you have.
You must know the way the handle you have currently is attached to the frame to choose the right replacement upvc handle. This is referred to as handing and it is an important piece of information to know when shopping online. Certain handle styles do not fit all windows. For instance, certain cockspur handles are angled, whilst others are straight and will either turn left or right. You will also need to know what the spindle length is that is the distance from the base of the handle to the top of the handle.
Another aspect to consider when choosing the right handle is determining whether your windows require a restrictor or not. These are usually used in high-rise apartments or https://www.redly.vip commercial properties, but they’re not a requirement for homes that are mostly domestic. Additionally, you must take into consideration step height, which is the distance from the bottom of the screw plate to the top of the handle.
Spade is a word that comes from Old English spadu or spaedu and has been translated in various languages, including German spaten and Low German Spathen. In the 1920s during the Harlem Renaissance in New York City spade started to be used as a sexist term for black people. The term has since come to prominence in pop culture and is now a well-known symbol of African American heritage and pride.
When replacing a Cadenza style handle, it’s crucial that you get the right size. The handles are available in straight and angled versions that differ by just a few millimetres. The handle head can change between a D and a T-shaped shape, or have no handles at all.